Edimax WAP1750 Uživatelský manuál Strana 16

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 232
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 15
AP Mode
10
III. Quick Setup
Your access point can be up and running in just a few minutes. This quick
installation guide will help to set up your access point in its default AP mode
and configure its basic settings. For use a Managed AP within an AP array no
settings are necessary. Configurations can be made from your Controller AP
(refer to Edimax Pro NMS).
III-1. Initial Setup
1. Connect the access point to a computer via Ethernet cable.
2. Connect the power adapter to the access point’s 12V DC port and plug the
power adapter into a power supply using the included cable.
3. Please wait a moment for the access point to start up. The access point is
ready when the LED is blue.
4. Set your computer’s IP address to 192.168.2.x where x is a number in the
range 3 100. If you are unsure how to do this, please refer to the user
manual for more information.
Please ensure there are no other active network connections on
your computer (disconnect Wi-Fi connections and Ethernet
cables).
5. Enter the access point’s default IP address 192.168.2.2 into the URL bar of
a web browser.
Zobrazit stránku 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 231 232

Komentáře k této Příručce

Žádné komentáře