Edimax N-9210TX-64 Instalační příručka stáhnout pdf (Strana 12)

12. You may test the connectivity of the Wi-Fi extender by connecting to it

(select its SSID from your list of wireless networks, not the SSID of your

root Wi-Fi access point) and attempting to open a web page with your web

browser.

13. After you have connected the extender to the existing Wi-Fi network and

confirmed it works, you can move this extender to another location for

optimal Wi-Fi extension. To move the extender, turn off the device and

unplug it from its socket. The extender will remember the Wi-Fi network it

is assigned to. Move the extender to its new location and plug it in, then

turn the device on again. The extender will go through its initialization

process after being turned on. You will be unable to connect to the

extender while it is initializing. When the green Wi-Fi LED ( ) begins

flashing irregularly and the orange Signal Strength LED ( ) activates, the

extender is ready for use.

For best results, install the extender at a location where the Signal Strength

LED ( ) remains on without blinking. This indicates it is receiving a strong

signal from the root wireless access point.

Resetting the Wi-Fi Extender

If your Wi-Fi extender is not functioning correctly, or if you want to run iQ

Setup again, press and hold the WPS button for 10 seconds to reset the

extender to factory defaults. The Power LED ( ) will flash when the device

begins the process of resetting to factory defaults. When the Power LED ( )

stays on and the Wi-Fi LED ( ) begins flashing irregularly, the Wi-Fi extender

has returned to factory default settings and is ready for setup.

Note: Releasing the WPS button too soon may

result in unintended behavior, such as the extender

attempting to begin WPS setup.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Žádné komentáře

Edimax N-9210TX-64 Instalační příručka Strana 12